The difference between spring machine and spring press machine.

The key of spring press is the control system. Spring compression machinery is developed from the previous electrical mechanical control to the electromechanical integration of CNC computer spring machinery. The mechanical control system of the compression spring is mainly composed of bus, CPU, power supply, memory, operation panel and display screen, position control unit, programmable controller logic control unit and data input/output interface. What are the production steps of spring press machine?

1. Before starting the spring machine, the operator must check whether the lubrication and protective equipment of the various parts of the machine tool meet the requirements, and the operation can be performed after confirmation.

2, the operator of the spring press machine must wear labor protective equipment according to the regulations, do not wear slippers, sandals and high heels. Do not cut gloves, ethnic towels, rings, necklaces and other accessories during operation. Don't smoke, don't talk to people, focus.

3. It is strictly prohibited to melt and play in the workshop. Operators must be familiar with the relevant information in the CNC machine manual. For example, the main technical information, transmission principle, main structure, lubrication parts and maintenance knowledge.

4, for the use of the spring press environment. It is necessary to anticipate direct light and other thermal radiation, excessive phlegm or excessive dust, corrosive gases, etc. at the site of use.

5, it is strictly prohibited to measure and touch the workpiece when the workpiece is rotating. The spring machine is not allowed to open the electrical cabinet door during normal operation, please press the "emergency stop" or "reset" button.

6. Before loading the workpiece into the spring press machine. The operator must run the program once and for all. Whether the powder process can run smoothly, whether the knife and the center device are installed correctly, whether there is an overshoot phenomenon. The operator must confirm that the workpiece is tight before starting the machine.

7, the start and stop sequence of the spring machine must be operated in accordance with the specifications of the machine.

8. Before the spindle starts cutting. The operator must close the protection policy, and it is strictly forbidden to open the protection door during the normal operation of the program.

9, all the experiments or practices of the spring press must be carried out under the guidance of the practice teacher. Do not start the machine without the instructor's permission.

10, after the spring machine is powered on, the operator should check whether the switch, button, button is normal and flexible, and whether the machine tool is abnormal.